Details

• Brand:

  

  

• SKU:

  WR-6059

• Other Names:

  Motorcraft™ Cable Set, Wire Assembly Ignition

• Description:

  This Genuine Ford Motorcraft spark plug wire set delivers high-voltage current from the ignition coil to each spark plug on the 2.3L four-cylinder engine used in the Ford Ranger built from 2001 through 2011. The wires carry ignition spark reliably while suppressing radio-frequency interference, using silicone insulation that resists engine-bay heat, oil, and abrasion so spark energy reaches each cylinder without leakage or crossfire. Over time original ignition wires break down: insulation hardens and cracks, conductor resistance climbs, and spark energy bleeds to ground. A driver experiencing a rough idle, engine misfire, hesitation under acceleration, a flashing or steady check engine light with misfire codes, hard starting, or reduced fuel economy is often chasing failed plug wires. Renewing the complete wire set restores a clean, consistent spark path to every cylinder and eliminates the intermittent misfires that a single degraded wire can cause. Ford catalogs this Motorcraft assembly under part number WR-6059 as the ignition wire cable set for the Ranger 2.3L application. Route the new wires exactly as the originals were positioned, seating each boot fully onto the plug and coil tower until it clicks, and keep the wires clear of hot exhaust components to prevent premature heat damage. Installing a fresh, correctly routed wire set is the most direct way to return smooth idle, crisp throttle response, and proper combustion to a high-mileage Ranger.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov