Details

• Brand:

  

  

• SKU:

  W709373-S439

• Positions: Front, Left, Right
• Other Names:

  Stabilizer Link Bolt, Bolt

• Description:

  This is the Genuine Ford front suspension stabilizer bar link bolt, cataloged by Ford as the Stabilizer Link Bolt, used to secure the stabilizer or sway bar link on 2005 through 2010 Ford F-250, F-350, F-450 and F-550 Super Duty trucks. It is an M14 hex-head fastener fitted at the left and right front link positions and applies across the Super Duty engine lineup, including the 5.4L V8, 6.8L V10, 6.0L Power Stroke diesel and 6.4L Power Stroke diesel, in both four-wheel-drive and rear-wheel-drive monobeam front-axle configurations. The stabilizer bar link ties the sway bar to the suspension so the bar can resist body lean during cornering, and this bolt clamps that link joint and holds it under proper preload. When the bolt is corroded, stretched, seized or improperly torqued, the connection can rattle or clunk over bumps, body-roll control feels vague, and in severe cases the link can loosen or separate from the bar. Ford releases this bolt as the correct service hardware for the front stabilizer link, so it is the right replacement whenever the sway bar, link, or bushings are serviced and the original fastener is damaged or no longer holding torque. Install the bolt clean and dry unless the workshop procedure specifies otherwise, and tighten to the Ford torque specification for the front stabilizer link so the joint is clamped correctly and the sway bar can do its job. Always confirm the exact part against your truck's VIN and the front suspension section of the Ford parts catalog before installation to be sure the thread size, length and application match your Super Duty.

• Replaces:

  w709373s426

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov