Details

• Brand:

  

  

• SKU:

  DG-514

• Other Names:

  Motorcraft™ Ignition Coil, Coil Assembly Ignition

• Description:

  This genuine Motorcraft coil on plug ignition coil delivers the high-voltage spark that ignites the air-fuel mixture on the 3.0L Duratec V6, mounting directly on top of the spark plug for each cylinder. It fits 2006 to 2012 Ford models equipped with the 3.0L V6, including the Fusion and Escape, along with the Mercury Milan and Mariner and the Lincoln Zephyr of the same era. Each cylinder uses its own coil, so a single failed unit produces a misfire isolated to that cylinder. A driver shopping for this part is typically dealing with a rough or shaking idle, stumbling and hesitation during acceleration, a check engine light accompanied by a misfire trouble code, poor fuel economy, or difficulty starting when a coil breaks down under heat and vibration. Over time the internal windings and the rubber insulating boot degrade, allowing spark to leak to ground rather than crossing the plug gap. Installing this Motorcraft coil restores correct spark energy and returns the V6 to smooth, even running. Built to Ford original equipment specification, it arrives with the correct molded boot and connector for a direct fit with no cutting or adapters. As with any ignition repair, inspect the spark plug under the coil while access is open and press the boot fully onto the plug so it seats and locks. No programming or calibration is needed after installation.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov