Details

• Brand:

  

  

• SKU:

  9E5Z-5K751-A

• Positions: Left Lower, Right Lower, Rear Lower Lower, Rear Lower
• Other Names:

  Adjust Bolt, Suspension Control Arm Bolt, Alignment Camber Adjusting Eccentric, Adjuster

• Description:

  This Genuine Ford adjust bolt, cataloged under base 5K751 as a Lower Control Arm Adjust Bolt, is the rear-suspension alignment cam bolt for the 2010 through 2012 Ford Fusion and Mercury Milan. It passes through the rear lower control arm at its inboard mount and carries an eccentric cam washer, so rotating the bolt shifts the control arm inboard or outboard to set rear wheel alignment. Depending on the mounting location it adjusts rear camber or toe, letting a technician dial the rear wheel back to the factory alignment specification after suspension work or when a car is pulling, wearing tires unevenly, or sitting off-spec. Owners and shops need this bolt when the original cam bolt is seized, rusted solid, rounded off, or snaps during an alignment, which is common on the rear suspension where road salt and moisture attack the fastener over years of service. Because it is a threaded suspension fastener that sets a safety-critical alignment angle, it must be torqued to the Ford specification and the alignment reset on an alignment rack after installation. As a genuine Ford component it matches the original bolt diameter, thread, cam profile, and length so the eccentric sweeps the correct adjustment range and clamps securely once set. It is good practice to replace the cam bolt and its hardware rather than reuse a corroded fastener, and to check the control-arm bushing while the bolt is out. Confirm the bolt matches your rear control-arm mount before installation.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov