Details

• Brand:

  

  

• SKU:

  BKCOE-24

• Positions: Rear, Left, Right, Front
• Other Names:

  Motorcraft™ Disc Brake Caliper Pin, Motorcraft™ Mount Kit, Motorcraft™ Repair Kit, Motorcraft™ Caliper Support Mount Kit, Motorcraft™ Caliper Mount Kit, Kit Brake Caliper Attachment

• Description:

  This genuine Ford Motorcraft disc brake caliper bolt kit is the OEM caliper attachment hardware set that secures the brake caliper and its mounting bracket, including the guide pins, bolts, and dust boots that let the caliper slide smoothly on its mounts as the pads wear. Ford catalogs it as a Disc Brake Caliper Bolt Kit, and it applies to 2010 through 2019 Ford models built with standard-duty non heavy-duty brakes, including Taurus in SE, SEL, Limited, and SHO trims, covering both two-wheel-drive 2010-2012 and all-wheel-drive 2013-2019 applications. The kit supplies the guide pins, bolts, and boots needed to service a caliper. Technicians install fresh caliper hardware whenever the guide pins seize, bind, or corrode, when a torn boot lets water and grit contaminate the slide pin, or during a brake job to restore free caliper movement; sticking pins cause uneven or premature pad wear, brake drag, pulling, and overheating. Clean or replace the pins together, apply the correct high-temperature caliper slide grease to the pins, seat the boots fully so they seal, and torque the caliper and bracket bolts to Ford specification. These caliper attachment bolts are torque-critical fasteners; fit the new hardware supplied rather than reusing worn bolts and tighten to the published Ford torque value to keep the caliper securely located. Restoring proper slide-pin function ensures even pad wear and consistent, quiet braking.

• Notes: Included with caliper support. Part cannot be reused/reinstalled.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov