Details

• Brand:

  

  

• SKU:

  TX-1115

• Positions: Right, Front Right Right
• Other Names:

  Motorcraft™ Cv Axle Assembly, Shaft Front Axle

• Description:

  This genuine Ford Motorcraft CV axle assembly is the complete right front, passenger side driveshaft for the 2011 through 2019 Ford Explorer. Working as the final drive link, it carries torque from the front power transfer unit to the right front wheel through a pair of constant velocity joints, letting the wheel deliver power while simultaneously steering and following the suspension's motion. The part is supplied fully assembled with inner and outer joints, protective boots, and factory grease packed and sealed, so it installs as a single ready-to-fit unit. A driver typically searches for this axle after hearing a sharp clicking while turning, feeling a vibration or shudder under acceleration, spotting slung grease coating the inner fender from a ruptured boot, or noticing a clunk when the drivetrain loads and unloads, each pointing to a deteriorated CV joint. Fitting a complete assembly renews both joints and both boots together, which is usually the more durable repair than servicing a single failed joint. Because the job separates the hub and axle hardware, the axle retaining nut is a single-use fastener that must be replaced and torqued to the specified value to correctly load the wheel bearing; reusing the old nut risks looseness. Additional parts may be needed during the replacement, so inspect surrounding seals and fasteners while the axle is out. Verify the right front position and correct Explorer application for your vehicle before ordering. Supplied as an each complete halfshaft to restore quiet, reliable drive to the right front corner.

• Notes: Additional parts may be required when replacing axle assembly.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov