Details

• Brand:

  

  

• SKU:

  BE8Z-6C315-A

• Other Names:

  Crankshaft Sensor, Crankshaft Position Sensor, Sensor Crankshaft Position

• Description:

  This genuine Ford crankshaft position sensor monitors the rotational speed and angular position of the crankshaft on the 2011-2019 Ford Fiesta with the 1.6L four-cylinder engine, reading a toothed reluctor ring or trigger wheel and feeding the powertrain control module the signal it uses to time fuel injection and spark and to calculate engine speed. A failing sensor is a common cause of no-start and stalling complaints, since the module will not fire injectors or coils without a valid crank signal. Buyers reach for this part when they experience intermittent stalling, hard or no start especially when hot, sudden loss of tachometer signal, rough running or misfire, or a stored crankshaft position sensor circuit trouble code. Ford catalogs it as Engine Crankshaft Position Sensor under BE8Z-6C315-A for the 1.6L Fiesta. The sensor mounts at the front cover or block near the crankshaft and connects through a sealed electrical connector; installation is straightforward, requiring correct seating against its mounting boss, an intact O-ring or gasket where used, and a fully latched connector. No special programming is required, though clearing stored codes and confirming a stable engine-speed signal after replacement is good practice. This is a genuine Ford OEM sensor built to factory signal accuracy and connector fit.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov