Details

• Brand:

  

  

• SKU:

  DG9Z-6038-J

• Positions: Front
• Other Names:

  Engine Mount, Front Mount, Bracket Engine Front Support

• Description:

  The DG9Z-6038-J is a genuine Ford engine front support bracket, cataloged by Ford as Bracket - Engine Front Support, that locates the front of the powertrain to the subframe and works with the mount insulator to control engine movement. It fits the 2013 through 2016 Ford Fusion and Lincoln MKZ equipped with the 2.0L EcoBoost four-cylinder engine, across front-wheel and all-wheel drive layouts and the available automatic and manual transaxles. This structural bracket carries engine weight and reacts driveline torque during acceleration and braking, keeping the powertrain aligned so the axles, exhaust, and accessory drive stay in their intended positions. When the original bracket or its bonded rubber is worn, cracked, or collapsed, drivers commonly notice increased vibration through the floor and steering wheel, a clunk or thump when shifting into gear or lifting off the throttle, and harsh shudder felt at idle or under load. Because it is a stamped and machined structural piece rather than a routine wear item, fitting the correct Ford component restores factory clearances and prevents the driveline stress a mismatched part can cause. Install the bracket to Ford's specified torque sequence and inspect the mating mount and hardware while the assembly is apart; any single-use or torque-to-yield fasteners removed during the repair should be replaced rather than reused to maintain proper clamp load. Confirm your engine and drive configuration against the listed years and models before installation.

• Applications: 2.0L W/O HYBRID.
• Replaces:

  DG9Z6038C

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov