Details

• Brand:

  

  

• SKU:

  CV6Z-19C734-A

• Positions: Upper
• Other Names:

  In-Car Sensor, In-Car Temp Sensor, Refrigerant Temp Sensor, Sensor Assembly, yh1811

• Description:

  This genuine Ford in-car temperature sensor measures the temperature of the air inside the cabin and reports it to the automatic climate control module, which uses the reading to regulate blend-door position, blower speed, and compressor operation so the system holds the temperature the driver selects. It fits a broad 2013-2023 range of Ford Escape, Focus, Fusion, C-Max, Lincoln MKC, and Transit Connect vehicles equipped with automatic temperature control, and many installations pair the sensor with a small aspirator that draws cabin air across the thermistor for an accurate sample. When this sensor drifts or fails, the climate system may blow air that is too hot or too cold, cycle the blower erratically, ignore the temperature setpoint, or store an HVAC fault code, which is why buyers replace it while chasing inconsistent automatic-climate behavior. Installing the genuine Motorcraft-grade sensor restores the calibrated resistance curve the control module expects, something generic thermistors do not always match. Ford catalogs this under base number 19C734 as the temperature sensor, and the A suffix is the widely shared service part across these platforms. It is a small electronic component typically clipped into the dash or console near an aspirator vent, and replacement usually involves removing a small trim panel, unclipping the connector, and transferring the sensor without any programming. Verify the vehicle uses automatic temperature control before ordering, then the calibrated sensor lets the climate system read cabin temperature accurately again.

• Notes: Included with AC & heater assembly.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov