Details

• Brand:

  

  

• SKU:

  W500635-S439

• Other Names:

  Bolt

• Description:

  This is a genuine Ford M10 x 35MM hex-head mounting bolt used to secure the Power Transfer Unit (PTU) and related driveline brackets on all-wheel-drive Ford applications, including the 13-19 Escape. The bolt threads into the PTU housing and clamps it to the transaxle or sub-frame, holding the unit in correct alignment so the driveshaft and rear axle receive power without excess vibration. A loose, corroded, or stretched bolt at this location can let the PTU shift, producing a driveline clunk, an oil leak at the mating surface, or a vibration that builds with speed. Drivers replacing a leaking PTU seal or installing a remanufactured transfer unit typically renew these fasteners because the original may be a torque-to-yield design that should not be reused once loosened. Built to Ford engineering specifications for the correct grade, thread pitch, and finish, this fastener matches the original equipment fit and corrosion resistance. Always torque to the value listed in the Ford workshop manual for the specific application and follow any specified tightening sequence. Confirm fitment against your VIN and the Ford parts catalog before ordering, since the same base bolt is shared across several driveline locations. Installing the correct OEM bolt protects the PTU mounting bosses and helps maintain the proper clamp load over the life of the repair.

• Notes: Included with drive shaft. Part cannot be reused/reinstalled.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov