Details

• Brand:

  

  

• SKU:

  DT1Z-19H421-AB

• Positions: Rear
• Other Names:

  Support Bracket, Bracket

• Description:

  This genuine Ford bracket is the rear park assist camera support bracket for the 2014-2018 Transit Connect. It mounts inside the tailgate and liftgate structure and holds the reverse camera in the correct position and aim so the backup image lines up with the vehicle guidance overlay. It fits left-hand-drive Transit Connect vans and wagons equipped with the factory rear camera system. A buyer usually needs this bracket when the camera has been knocked loose, the original bracket is cracked or its tabs are broken after tailgate service or a rear impact, or the camera image sits crooked or vibrates. Because camera aim depends on this bracket, use the correct part so the image and any parking guidelines register properly; inspect the camera and its connector while the trim is open, and confirm a clear, level reverse image after reassembly. Installation involves removing the tailgate interior trim panel to reach the bracket and transferring the camera. As a genuine Ford component it provides the exact mounting geometry of the original, avoiding the misaligned or shaking image that results from a makeshift or ill-fitting bracket. Confirm your vehicle has the factory rear camera before ordering.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov