Details

• Brand:

  

  

• SKU:

  DT1Z-15A201-CA

• Positions: Rear
• Other Names:

  Molding, Lamp Assembly Rear

• Description:

  This is the rear lamp assembly for 2014-2018 Ford Transit Connect models built with the 1.5L Duratorq diesel, 2.0L Duratec, or 2.5L Duratec engine, covering both automatic-transmission and front-wheel-drive left-hand-drive configurations sold during this generation. The lamp mounts to the rear body panel near the cargo doors and houses the bulbs and lens needed for rear marker, running, and signal illumination in that corner of the van, sealing against the body opening to keep moisture out of the harness connector and bulb sockets. Buyers look for this part after the lens has cracked or clouded from age and road debris, after water has intruded into the housing and fogged the lens or corroded a bulb socket, or after a dim, flickering, or completely dark lamp shows up during a walk-around inspection or roadside safety check. A cracked lens or failed seal can also let corrosion creep into the connector, so a lamp that flickers intermittently over bumps is often a housing or seal problem rather than a simple bulb failure. Because Transit Connect body styles and lamp mounting points changed between the pre-facelift and facelift years, confirm your exact model year and cargo-door configuration before ordering, since a visually similar rear lamp for the later-generation van will not share the same mounting tabs or connector shape as this earlier-style unit. Installation involves removing the interior trim or access panel behind the lamp, disconnecting the wiring harness plug, releasing the retaining fasteners or clips holding the lamp to the body, and pressing the new unit into the sealed opening before reconnecting the harness and refitting the interior trim. No core charge or module programming applies to this lighting component.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov