Details

• Brand:

  

  

• SKU:

  W718197-S437

• Description:

  This is a genuine Ford engine mount bolt, catalogued as an M8 x 20MM hex bolt and used as an engine mounting and general structural fastener across a range of Ford vehicles including EcoSport, Focus, Transit, and the F-250 and F-350 Super Duty. It provides the threaded clamp that secures an engine mount bracket, mount isolator, or related structural component, carrying both shear and clamp load so the assembly stays rigidly located and does not shift under engine torque or road input. Because it can sit at a mount point that carries engine load, a clean, correctly torqued bolt is important to keeping the mount tight and the driveline isolated. Owners reach for this bolt when the original has corroded, stripped, or been damaged during engine mount or bracket service, or when a mount is being replaced and fresh hardware is required to restore the factory clamp. It is commonly renewed together with the mount or bracket so the joint clamps evenly. Manufactured to Ford specifications, it matches the original M8 thread, length, and head so it threads into the host boss and installs in the original location without modification. Always confirm the threaded boss is clean and the bracket hole is undistorted before installation, start the bolt square to avoid cross-threading, and torque to the value given in the applicable engine mounting service section. Inspect the mount, bracket, and bolt holes for cracks or elongation while the hardware is out, since a worn mount will not stay tight under load.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov