Details

• Brand:

  

  

• SKU:

  EV6Z-9F836-E

• Other Names:

  Pedal Travel Sensor, Pedal

• Description:

  This is the drive-by-wire accelerator pedal travel sensor assembly for the Ford Focus, the electronic pedal module that replaces the old mechanical throttle cable. Integrated dual sensors read how far and how fast the driver presses the pedal and send redundant signals to the powertrain control module, which then commands the electronic throttle body to open accordingly. The redundancy is a safety feature: if the two signals disagree, the module detects the fault and drops the engine into a reduced-power limp mode. It fits 2015 through 2018 Ford Focus models and mounts to the pedal bracket under the dash. Buyers replacing this part are typically chasing a stored accelerator pedal position sensor code, an unexpected drop into failsafe or limp mode, hesitation or a dead spot when pressing the pedal, a wrench or powertrain warning light, or an engine that will not rev past idle. Because the sensor and the physical pedal are supplied together as one calibrated assembly, this replacement restores correct pedal geometry and signal output in a single part rather than requiring separate sensor and pedal service. As a genuine Ford component it carries the factory signal calibration the control module expects, avoiding the mismatched voltage ranges that cause non-genuine pedals to set new faults. Installation is a direct bolt-in swap of the connector and mounting fasteners; no separate programming is required for this application, though clearing stored codes and a brief relearn drive cycle are recommended after replacement.

• Notes: Includes Accelerator Pedal.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov