Details

• Brand:

  

  

• SKU:

  FV6Z-19C734-B

• Positions: Upper
• Other Names:

  In-Car Sensor, Sensor Assembly, yh1965

• Description:

  This genuine Ford sensor assembly is the air conditioning evaporator temperature sensor for the 2015 through 2019 Escape. It mounts at the evaporator core inside the HVAC housing and reports the temperature of the evaporator to the climate control system, which uses that signal to cycle the compressor and prevent the evaporator from freezing over while maintaining the cabin cooling the driver has selected. When this sensor drifts or fails, the system can lose cooling performance, blow warm intermittently, allow the evaporator to ice up and restrict airflow, or set climate related diagnostic trouble codes. Buyers searching for this part are usually chasing weak or inconsistent A/C output, an evaporator that freezes and then thaws, or a stored fault pointing to the evaporator temperature circuit. Ford lists it under the catalog name Sensor Assembly and it also carries the A/C Evaporator Temperature Sensor description in dealer catalogs. Replacing the sensor with the correct genuine unit restores accurate temperature feedback so the compressor clutch cycles properly and full cooling capacity returns. Access typically requires removing trim and portions of the HVAC ducting to reach the evaporator case, so route the connector and seat the sensor fully into its port during installation. Confirm the sensor location and connector style against your vehicle before fitting, and inspect the wiring pigtail for corrosion or heat damage. As a genuine Ford part it matches the original calibration and fit for reliable climate system operation.

• Notes: Included with evaporator assembly.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov