Details

• Brand:

  

  

• SKU:

  EJ7Z-5493-B

• Positions: Left, Right, Rear
• Other Names:

  Bushings, Suspension Stabilizer Bar Bushing, Insulator Assembly

• Description:

  This genuine Ford stabilizer bar bushing is the molded rubber insulator that clamps the rear stabilizer sway bar to the vehicle body, allowing the bar to rotate under control while it resists body lean during cornering. As the bushing ages it hardens, cracks, or wears oversized, letting the bar shift within the mount; the classic result is a clunk, knock, or rattle over bumps and speed transitions, along with vague or sloppy handling and increased body roll. Ford catalogs this piece as a Stabilizer Bar Bushing, or insulator, for the rear bar. It fits 2015-2019 Lincoln MKC models, including those equipped with the continuous control damping suspension and all-wheel drive with electronically adjustable shocks. Because the two bushings on an axle wear at the same rate, replacing them as a matched pair on the rear bar is recommended so handling stays balanced side to side and the repair lasts; pairing new bushings with fresh mounting hardware where needed gives the most secure clamp. When installing, seat the bushing squarely in its bracket and torque the clamp fasteners to Ford specification, as an over- or under-clamped bushing can squeak or wear prematurely. Restoring the correct rubber isolation quiets the rear suspension and returns the crisp, controlled feel the chassis had when new. This is a genuine Ford component built to the original material and dimensional specification for a correct fit.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov