Details

• Brand:

  

  

• SKU:

  HC3Z-2282-H

• Positions: Right, Rear Right Right
• Other Names:

  Brake Hose, Flex Hose, Hose Assembly Brake, BRHR163

• Description:

  This Genuine Ford Hose Assembly - Brake is the flexible hydraulic brake hose that connects the frame-mounted steel brake line to the front caliper, allowing the brake fluid path to flex with steering and suspension travel while safely containing high-pressure hydraulic fluid on every stop. It carries confirmed dealer fitment for 2017-2022 F-250 Super Duty and F-350 Super Duty trucks in the passenger-side, or right-hand, mounting position, and it is used across the 6.2L gas, 6.7L Power Stroke diesel, and 6.8L V10 engine offerings for that generation. Drivers typically need this hose when they notice a soft or spongy brake pedal that sinks toward the floor, visible brake fluid leaking or wet residue near the front wheel and caliper, a cracked, bulging, or dry-rotted rubber section on the hose exterior, or an illuminated brake warning light tied to low fluid caused by a slow leak at this connection. This part is also cataloged under the names Brake Hose and Flex Hose and is supplied as a direct-replacement assembly for the original factory hose on this application. Because this hose carries pressurized brake fluid to a safety-critical component, the copper or aluminum crush washers at the banjo fitting are single-use and must never be reused once removed, and the hydraulic brake system must be properly bled of trapped air after installation to restore firm pedal feel and full braking performance. Inspect the routing clips and mounting bracket for proper alignment so the new hose does not contact the tire, wheel, or suspension components through the full range of steering travel.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov