Details

• Brand:

  

  

• SKU:

  JL7Z-17603-A

• Positions: Front
• Other Names:

  Spray Jet, Kit Jet

• Description:

  This genuine Ford part is the windshield washer spray nozzle, cataloged by Ford as Kit Jet and commonly listed as a washer nozzle or spray jet, for the 2018 through 2021 Lincoln Navigator with the 3.5L GTDI EcoBoost V6, in rear wheel drive and part time four wheel drive configurations with the 10R80 ten speed automatic. The nozzle threads into the hood or cowl panel and atomizes washer fluid delivered by the reservoir pump into a fan pattern across the glass so the wiper blades can clear road film, salt spray, bug residue, and winter grime without scratching. Each nozzle contains fine calibrated orifices and a check valve arrangement that holds prime in the line so spray begins immediately when the stalk is pulled. Buyers usually replace this part when one side of the windshield gets no fluid at all, when the spray dribbles down the hood instead of reaching the glass, when the pattern has shifted off target and hits the roof or the A pillar, or when the orifices are plugged with wax, dried washer fluid deposits, or debris that cannot be cleared with a pin. Cracked nozzle bodies from freezing fluid are another frequent cause of failure. Installation is straightforward: release the retaining clips from underneath the hood, disconnect the supply hose, seat the new jet until the tabs lock, and reconnect the hose. Aim can be fine tuned with a small pick. Using the correct Ford nozzle preserves the factory spray pattern and hose fitment rather than leaking at the connection.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov