Details

• Brand:

  

  

• SKU:

  JL1Z-7850463-AK

• Positions: Left
• Other Names:

  Molding

• Description:

  This genuine Ford roof molding is the driver side (LH) exterior roof ditch trim that finishes the joint where the roof panel meets the body side, concealing the roof seam and helping keep out water, wind noise, and road debris along the upper edge of the vehicle. It fits 2018 through 2024 Ford Expedition and Lincoln Navigator models built on the U553 platform with the 3.5L GTDI V6, offered for both the standard 122.5 inch and long 131.6 inch wheelbase configurations. Owners typically replace this molding when the original has faded, warped, lifted at the retention clips, or become cracked and brittle from prolonged sun and heat exposure, or when it was damaged during a car wash, roof rack service, or minor body work. A loose or missing roof molding often produces a wind whistle at highway speed and can allow water to track into the headliner or A-pillar area. This molding carries Ford part number JL1Z-7850463-AK and is the driver side counterpart to the passenger side JL1Z-7850462 series, molded to the exact contour of the roof channel and using the factory clips and locating features for a precise fit that matches the original appearance. Installation is straightforward, but inspect the retainer clips and replace any that are brittle, and clean the mating surface before seating the new molding so it locks fully along its length. As a genuine Ford component it matches the original grain, gloss, and color coordination for a factory correct result on the driver side roof line.

• Replaces:

  JL1Z7850462AC, JL1Z7850463AA, JL1Z7850463AJ

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov