Details

• Brand:

  

  

• SKU:

  W710233-S437

• Positions: Rear
• Other Names:

  Bolt

• Description:

  This is a genuine Ford drive shaft flange yoke bolt for the 19-23 Ranger, the M12 by 35mm fastener that clamps the rear drive shaft flange yoke to its mating companion flange in the driveline of these mid-size trucks. Ford dealer parts catalogs list it specifically for the 19-23 Ranger in the rear driveline position, covering four-wheel-drive and rear-wheel-drive builds, where it secures the propshaft flange connection that transmits torque along the driveline. Because this is a rotating-driveline fastener, it should be torqued to the published specification in the correct sequence and treated as a fastener that must hold precise clamp load under load reversal and vibration. A driver who notices a metallic clunk on acceleration, a vibration that builds with road speed, or visible play at the rear flange may have a bolt that has loosened at this joint, so Ford specifies fitting fresh hardware whenever the drive shaft is dropped for service. Inspect the threads and flange faces before reuse and replace the bolt if any distortion or thread damage is present. Supplied as an individual genuine Ford part, it matches the original material grade, thread form, and finish of the bolt that left the assembly line, so it seats correctly in the flange and accepts the specified torque without the fit or strength compromises common to generic hardware. Verify the rear driveline application against your VIN before ordering.

• Notes: Part cannot be reused/reinstalled.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov