Details

• Brand:

  

  

• SKU:

  W718169-S307

• Other Names:

  Bolt

• Description:

  This is a genuine Ford engine crankshaft position sensor bolt, catalogued as an M6 x 20MM bolt and used on the 2.3L EcoBoost and related engines in the Bronco, Bronco Sport, Escape, Ranger, and Transit across the 19-25 window. It is the threaded fastener that retains the crankshaft position sensor to its mounting boss on the engine, holding the sensor at a fixed, correct distance from the reluctor so the signal stays clean and the engine controller can read crank speed and position accurately. A correctly seated sensor bolt is important because a loose sensor can shift its air gap and cause erratic readings, hard starting, or stalling. Owners replace this bolt during crankshaft position sensor service, when the original has corroded or stripped, or when a no-start or misfire has been traced to a loose or backed-out sensor hold-down. Manufactured to Ford specifications, it matches the original M6 thread and length so the sensor seats at the correct depth in the original location without modification. Always confirm the threaded boss and the sensor mounting face are clean before installation, seat the sensor fully against its locating surface, and torque to the value given in the applicable engine controls service section so the air gap is held correctly. Inspect the sensor tip and reluctor for debris or damage while the bolt is out, since metal shavings on the sensor face will corrupt the signal even with the bolt correctly torqued.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov