Details

• Brand:

  

  

• SKU:

  W719491-S439

• Positions: Left, Right
• Other Names:

  Axle Hub Mounting Bolt, Bolt

• Description:

  This is a genuine Ford wheel hub assembly mount bolt for the 19-25 Ranger, the fastener that secures the front hub and bearing assembly to the steering knuckle. It carries the clamp load that holds the hub flange tight against the knuckle so the wheel bearing stays seated and properly preloaded under cornering and braking. Each bolt threads into the knuckle face around the hub bore, and the set retains the hub on both the left and right sides. Owners reach for this bolt during front wheel bearing or hub replacement, when chasing a humming or growling noise from the front end, after removing the hub for brake or axle service, or when the original hardware is corroded or damaged. This is a single-use fastener that cannot be reused once removed and must be replaced with new hardware to restore the correct clamp load. Reusing a fatigued bolt risks a loose hub, bearing damage, and unsafe wheel movement. Built to Ford specifications, it matches the original thread, length, and grade for a correct fit in the factory location without modification. Tighten it to the published Ford torque value in the proper sequence, and inspect the knuckle threads and hub mating surface for damage or rust before fitting new bolts. Confirm the part against the Ranger front hub and knuckle diagram for the build year and drive configuration before installation to ensure the correct hardware is used.

• Notes: Part cannot be reused/reinstalled.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov