Details

• Brand:

  

  

• SKU:

  W708888-SD

• Positions: Front, Left, Right
• Other Names:

  Wheel Arch Molding Rivet, Pin

• Description:

  This genuine Ford Wheel Opening Molding Rivet is the factory push-in fastener that secures the plastic wheel opening molding, or wheel arch trim, to the fender and rear quarter panel sheet metal on the 2020 Ford F-150. The rivet snaps into a pre-drilled hole through the molding flange and expands to clamp the trim tight against the body, keeping the molding aligned along the wheel arch so it resists wind lift, vibration, and road spray at highway speed. It is the correct retainer for the 2020 F-150 across the 2.7L EcoBoost, 3.0L Power Stroke diesel, 3.3L flex-fuel V6, 3.5L EcoBoost, and 5.0L V8 configurations. Buyers usually need this part after a molding has come loose, rattles, sits proud of the body, or was damaged during a fender, bumper, or quarter panel repair, and after any job where the old rivets sheared or crumbled on removal. Because the plastic barbs deform permanently as they seat, this is a single-use fastener and cannot be reused or reinstalled once removed; always replace it with a new rivet to guarantee full clamp load and a flush molding fit. Installing the original genuine Ford rivet keeps the wheel opening molding seated to factory specification, preserves the correct gap and flush appearance along the arch, and avoids the loose fit, buzzing, and premature trim loss common with generic substitute clips. Ford catalogs this component under the wheel opening molding hardware for the 2020 F-150, and it matches the original equipment size, barb geometry, and head diameter used at the assembly plant.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov