Details

• Brand:

  

  

• SKU:

  L1MZ-2C204-E

• Positions: Front, Left Front, Right Front
• Other Names:

  Front Speed Sensor, ABS Wheel Speed Sensor, Sensor Assembly, brab613

• Description:

  This is a genuine Ford front ABS wheel speed sensor assembly carrying the Motorcraft BRAB-538 designation, supplied with the integrated wire harness and connector. The sensor supersedes L1MZ-2C204-B in the same family and fits 20-24 Explorer and Police Interceptor Utility builds in both RWD and AWD driveline configurations, mounting at the front knuckle to read tone ring teeth on the wheel hub bearing. Output is a square-wave digital signal fed back to the ABS module, which uses the data to coordinate anti-lock braking, traction control, stability assist, and the various advanced driver assist features that rely on wheel speed reference. Drivers reach for this sensor when the ABS warning light comes on at start-up, when the traction control or stability light flashes during driving, when a scan tool returns a wheel speed sensor circuit fault at the front-left or front-right corner, or when corrosion has compromised the sensor pickup face after road salt exposure. The assembly installs with a single retaining bolt at the knuckle, with the harness routed along the inner fender liner per the factory clip locations. Verify the new sensor's connector key matches the harness pigtail before pressing it home, since left and right positions sometimes look interchangeable but route on different paths. Replace any damaged harness clips during reinstallation, since the sensor cable will fatigue and fail prematurely if it is allowed to chafe against suspension components or the brake hose. Initialize the system through the diagnostic scan tool if required after installation.

• Replaces:

  brab538, l1mz2c204b

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov