Details

• Brand:

  

  

• SKU:

  L1MZ-19892-A

• Positions: Upper
• Other Names:

  Seal

• Description:

  This is a genuine Ford radiator support panel upper seal, a molded rubber seal that mounts at the center of the radiator support to close the gap between the support panel and the upper hood-line bodywork. It fits 20-24 Explorer and 20-24 Police Interceptor Utility builds in the BASE, King Ranch, Limited, Platinum, ST, XLT, and Interceptor configurations whether equipped with or without the active grille shutter or fog lamp options. The seal channels incoming air through the radiator and condenser stack rather than allowing it to spill over the top of the cooling stack, which preserves cooling efficiency at low road speeds and protects the under-hood heat shield system from over-temperature events during sustained towing or idle-on-grade duty cycles. Owners reach for this part when the original seal is missing or fragmented after a front-end collision repair, when a body shop discovers the seal damaged during fender replacement, or when noticeable airflow loss is suspected from cooling complaints or fan-on-high-speed events under conditions the system should handle. The genuine Ford replacement arrives with the correct rubber durometer and the molded geometry that mates to both the radiator support edge and the underside of the hood when latched. Always inspect adjacent foam baffles, side air dams, and the lower air deflector at the same service since aerodynamic management of the cooling stack depends on the complete air seal package being intact. Install with the correct retainer clips and verify cooling temperature behavior remains within specification on a post-repair test drive.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov