Details

• Brand:

  

  

• SKU:

  LB5Z-13412-A

• Positions: Left, Right, Rear
• Other Names:

  Tail Light Wiring Harness, Socket And Wire Assembly Lamp

• Description:

  This genuine Ford Socket and Wire assembly is the tail lamp wiring pigtail and bulb socket that plugs into the rear tail lamp housing on the 2020 through 2024 Ford Explorer, including Police Interceptor Utility and hybrid variants. It carries the running, brake, and turn signal circuits to the tail lamp bulbs and provides the weather sealed connector interface between the body harness and the lamp assembly. The part is included with the tail lamp assembly from the factory and is serviced separately when the socket, terminals, or short pigtail become the failure point rather than the entire lamp. Typical symptoms that lead a buyer here include intermittent or dead brake and tail lamp function on one side, flickering rear lighting, melted or corroded socket contacts from a chronically overheated bulb, moisture intrusion at the connector, or bulb-out warnings that persist after a known good bulb is installed. Installing a fresh socket and wire restores clean electrical contact and correct bulb seating without replacing the whole lamp housing. This is the original Ford tail light wiring harness and socket, matching the factory terminal pinout and connector keying so no splicing or adapters are required. Verify the side and lamp configuration for your specific Explorer trim before installation.

• Notes: Included with tail lamp assembly.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov