Details

• Brand:

  

  

• SKU:

  HX7Z-9439-A

• Other Names:

  Intake Manifold Gasket, Gasket Intake Manifold

• Description:

  This is a genuine Ford intake manifold gasket for the 1.5L EcoBoost three-cylinder engine in 20-25 Bronco Sport and Escape vehicles. The gasket seals between the intake manifold and the cylinder head, ensuring a vacuum-tight seal so the engine can draw the correct air-fuel mixture under all operating conditions. A failing or improperly installed gasket creates a vacuum leak that causes a rough or unstable idle, lean misfire codes (P0171), increased fuel trim values reported by the powertrain control module, a hissing noise audible under the hood at idle, hesitation when accelerating from a stop, and a check engine light. Ford service procedures require replacement of the intake manifold gasket whenever the manifold is removed for fuel injector service, cylinder head work, or timing chain access. The gasket is a multi-layer steel design with integrated o-ring seals at each runner port. Install dry without sealant unless the service manual specifies otherwise, follow the specified bolt torque sequence, and verify cleanliness of the cylinder head sealing surface before installation to ensure long-term reliability. UNCONFIRMED specific vehicle fitment.

• Notes: Included with intake manifold.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov