Details

• Brand:

  

  

• SKU:

  MB3Z-1104-E

• Positions: Front, Left Front, Right Front
• Other Names:

  Front Hub & Bearing, Wheel Bearing And Hub Assembly, Hub Assembly Wheel

• Description:

  This genuine Ford front wheel hub and bearing assembly is the sealed, lubricated-for-life unit that carries the front wheel and integrates the wheel-speed sensor tone ring on 4WD applications of the 2021-2025 full-size Ford Bronco (without Raptor) and the Ford Ranger built to the 07/15/2024 cutoff. It combines the mounting flange, bearing, and ABS target into one serviceable module that bolts to the steering knuckle. A worn hub bearing announces itself with a cyclic humming or growling that rises with speed and changes with cornering load, along with possible ABS or traction-control faults, wheel-end play, or vibration. Installing this correct original-equipment assembly restores quiet, precise wheel support and reliable wheel-speed signal, protecting braking and stability systems that depend on it. This assembly replaces MB3Z-1104-A and matches the factory flange, bolt pattern, and sensor geometry for a direct fit on the original locating points. The hub mounting bolt is a single-use fastener and must not be reused; always install a new mount bolt and torque all hardware to Ford specification. Confirm your drivetrain and, for Ranger, your build date before ordering. Inspect the opposite side and replace hubs in pairs when high mileage or matched wear is a concern.

• Notes: Part has related component that cannot be reused/reinstalled. mount bolt.
• Replaces:

  mb3z1104a

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov