Details

• Brand:

  

  

• SKU:

  MB3Z-3B436-B

• Positions: Right Outer, Right Inner, Front Inner Outer, Front Inner Inner
• Other Names:

  Boot Kit, Outer Cv Joint Boot, Inner Cv Joint Boot, Kit Cv Joint Repair

• Description:

  This genuine Ford CV joint repair kit supplies the constant-velocity joint boot and service hardware for the passenger-side (right-hand) front halfshaft on the 2021-2025 Ford Bronco and 2024-2025 Ford Ranger. The boot is a flexible pleated seal that holds grease around the CV joint and keeps water, dirt, and road grit out while the joint flexes through steering and suspension movement; this kit lets a technician reseal the joint as an OEM repair instead of replacing the complete axle shaft. When a boot splits or tears, grease is thrown out and contaminants get in, causing rapid joint wear, a clicking or popping sound during turns, grease flung around the wheel and underbody, and ultimately joint failure. A buyer searching for this kit has typically found cracked or torn boot rubber or grease spray near the wheel and wants to save the halfshaft. Fitting the correct OEM boot kit re-establishes the grease seal and protects the CV joint for continued service. Thoroughly clean the joint, repack it with the specified grease, and seat the boot with its clamps properly so the seal stays airtight, since an improperly secured boot will fail again. Verify this is the right-side application; the left-side kit uses a different part number. Any single-use clamps or fasteners removed during the repair should be replaced rather than reused, and all hardware tightened to Ford's specification.

• Notes: Included with axle assembly.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov