Details

• Brand:

  

  

• SKU:

  LJ8Z-8C324-A

• Positions: Front
• Other Names:

  Housing, Insert Molding

• Description:

  This is the genuine Ford housing, also cataloged as an insert molding, for the front bumper camera on the 2021-2025 Mustang Mach-E equipped with the GT model bumper cover and trim. It provides the precise mounting pocket and finished surround for the forward-facing camera integrated into the GT front fascia, holding the camera at the correct angle and position so the parking views and 360-degree camera imaging render accurately. Because camera aim is critical to parking guidance and any forward camera-based driver-assist views, the housing must locate the camera exactly as the factory intended; a cracked, distorted, or mislocated housing can skew the image, obstruct the lens, or allow the camera to shift out of alignment. Owners need this part after front-end contact, bumper cover replacement or refinishing, or when the original housing was broken during service or damaged in a minor collision. It is specific to the GT bumper configuration; non-GT Mach-E front bumpers use different components, so confirm that your vehicle carries the GT model bumper and the front camera option before ordering. Inspect the camera and its harness while the housing is off, and seat the new housing fully so the camera lens sits clean and unobstructed. Verify your trim, camera equipment, and VIN configuration before installing. As a genuine Ford part it provides the exact fit and lens clearance that a universal or modified piece cannot, preserving correct camera aim and a factory appearance in the front fascia.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov