Details

• Brand:

  

  

• SKU:

  LJ8Z-14D202-J

• Positions: Front
• Other Names:

  Wire Harness, Cable Assembly

• Description:

  This genuine Ford wiring harness routes the signal and power connections for the front park assist camera system on the Mustang Mach-E, linking the forward-facing camera module into the vehicle's driver assistance and surround-view network. It carries the video feed and control lines that allow the camera image to display on the center touchscreen during low-speed maneuvering and parking. Correct fitment covers 2021-2025 Mustang Mach-E electric crossovers. A buyer typically needs this harness when the front camera image is intermittent, blank, or shows connector faults, or when the original loom has been damaged during front bumper, grille, or fascia service. Because the connectors and pin layout are application-specific, a generic harness will not seat or communicate correctly, and using the wrong loom can trigger park assist and camera fault messages. Installation runs behind the front fascia and along the body structure, so the fascia usually must be partially removed for routing. Ford catalogs this part as a park assist camera wiring harness; confirm your Mach-E is equipped with the front camera option before ordering, and inspect connector locks and retainers during install to avoid chafing against sharp edges. The harness is supplied as the complete OEM assembly for a correct, corrosion-resistant connection.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov