Details

• Brand:

  

  

• SKU:

  W721614-S439

• Positions: Left, Right
• Other Names:

  Suspension Ball Joint Bolt, Bolt

• Description:

  This is the genuine Ford suspension ball joint mount bolt, catalog number W721614-S439, for the Ford Maverick from the 22 through 24 model years, usable on the left or right side. Ford lists it in the front suspension hardware group as an M12 by 62mm ball joint mount bolt. It fastens the ball joint to its knuckle or control arm mounting at the engineered clamp load, holding a steering and suspension joint that carries cornering, braking, and road loads, so correct installation is safety-critical. Buyers searching for this bolt are typically replacing a worn ball joint or control arm, rebuilding front suspension, or chasing a clunk, creak, or knock during turns and over bumps traced to loose or previously over-stressed ball joint hardware. A bolt that is loose, stretched, or installed below specification lets the joint shift in its mounting, which produces a clunk or creak, causes uneven tire wear, and can allow the joint to separate under load. Ford specifies this as a single-use fastener torqued to yield, so it must not be reused once removed, and fresh hardware is required to restore the correct clamp load and keep the joint secure. As a genuine Ford component it matches the original thread form, grade, diameter, and length exactly, so it seats fully and torques to the factory figure without thread damage. Installing the correct original bolt keeps the ball joint solidly mounted so the front suspension and steering stay safe and tight. This listing is for the genuine Ford bolt built to original specification.

• Notes: Part cannot be reused/reinstalled.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov