Details

• Brand:

  

  

• SKU:

  E6TZ-5486-B

• Positions: Left, Right, Front
• Other Names:

  Bracket, Stabilizer Bar Bracket, Stabilizer Bar Clamp

• Description:

  This genuine Ford front stabilizer bar bracket, cataloged as a Stabilizer Bar Bracket and often called a sway bar bracket or clamp, secures the front stabilizer anti-roll bar to the frame so the bar can resist body roll during cornering. The bracket holds the bar and its bushing firmly against the chassis while allowing the bar to twist as the suspension works, which keeps steering response crisp and the vehicle stable through turns. It fits a long run of 1986-2008 Ford vehicles, primarily the E-150, E-250, E-350, and E-450 Econoline vans along with the Bronco and related F-Series applications, making it a widely used chassis service part. A worn or corroded bracket, or a bracket paired with a deteriorated bushing, lets the stabilizer bar shift and knock, producing clunks or rattles over bumps, vague or wandering handling, and excess body lean in corners. Road salt and age commonly rust these brackets until the mounting flange weakens or the fasteners seize. Replacing the bracket restores the solid mounting the stabilizer bar needs to do its job. This genuine part matches the original stamping, mounting-hole pattern, and bushing seat so it bolts to the factory locations without drilling or modification. Inspect the stabilizer bar bushing while the bracket is off and replace it if it is cracked or flattened, since a fresh bracket on a worn bushing will still allow movement and noise. Clean the mounting surface, start all fasteners by hand to avoid cross-threading, and tighten to the Ford torque specification. Confirm the front-suspension application and side for your specific van or truck before installing, since bracket shapes varied across this broad range of years and models.

• Applications: 1999-07 SUPER DUTY.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov