Details

• Brand:

  

  

• SKU:

  PW-507

• Other Names:

  Motorcraft™ Water Pump, Motorcraft™ Water Pump Assembly, Pump Assembly Water

• Description:

  This is the genuine Ford Motorcraft engine water pump for 1995 through 2008 Ranger pickups equipped with the 3.0L Vulcan V6, supplied as a complete pump assembly. The water pump is belt-driven and circulates coolant through the block, cylinder heads, and radiator to remove engine heat and maintain the correct operating temperature across city driving, highway use, and light towing. As a full assembly it brings a fresh impeller, bearing, shaft, and seal on the correct mounting flange so the sealing surfaces and pulley alignment match the factory setup. A buyer looking for this pump is usually chasing a coolant leak from the weep hole, a noisy or rough pump bearing, a pulley that wobbles, coolant pooling at the front of the engine, or an overheating gauge. Replacing a marginal pump before it fails helps avoid an overheating event that can warp the aluminum heads on this engine. Installation involves draining the cooling system, removing the drive belt and any accessories in the way, cleaning the block sealing surface completely, fitting the new pump with a fresh gasket, and torquing the fasteners in sequence, then refilling with the correct Ford coolant, bleeding the system, and confirming normal temperature with no leaks. Verify the engine is the 3.0L V6 before ordering, since the water pump differs from the other Ranger engine offerings of this era.

• Applications: 2.9L, 3.0L, 4.0L.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov