Details

• Brand:

  

  

• SKU:

  W701259-S300

• Positions: Left Outer, Left Rear, Left Inner, Left Upper, Right Outer, Right Rear, Right Inner, Right Upper, Center Outer, Center Rear, Center Inner, Center Upper, Rear Outer, Rear, Rear Inner, Rear Upper
• Other Names:

  Fender Liner Retainer Clip, Air Deflector Retainer Clip, Bumper Cover Clip, Deflector Retainer Clip, End Cap Clip, Rear Molding Retainer, Inner Shield Clip, Wheelhouse Liner Retainer Clip, Rear Panel Clip, Splash Shield Clip, Splash Shield Retainer Clip, Side Reinforced Clip, Deflector Panel Retainer Clip, Rear Trim Clip, Seal Strip Rivet, Cowl Grille Retainer, Fender Ledge Cover Retainer, Strap Retainer, Upper Insulator Retainer, Tank Strap Clip, Floor Duct Clip, Upper Reinforced Clip, Wheelhouse Liner Fastener, Heat Shield Clip, Fender Liner Retainer, Pkg Tray Cover Retainer, Fuel Tank Shield Clip, Quarter Panel Splash Shield Clip, Bumper Corner Cover Clip, Bumper Cover Retainer, Radiator Support Air Deflector Clip, Tank Shield Retainer Clip, Side Shield Retainer Clip, Wheelhouse Liner Clip, Heat Shield Retainer Clip, Radiator Support Splash Shield Clip, Rocker Molding Clip, Pin Trim

• Description:

  The W701259-S300 is a genuine Ford retainer clip built on the HC1 base, a push-in service clip used to hold fender liners, side air baffles, side shields and rear body mouldings to the body without threaded fasteners. Dealer catalogs carry it under the dominant names Fender Liner Retainer Clip and Side Air Baffle Retainer Clip in the exterior mouldings and trim section, and note that it is included with the side shield and with the rear molding. Documented sample applications where this exact service number is cataloged include the Ford Bronco, E-350 and F-150 and the Lincoln Continental, Navigator and Zephyr, along with the Mercury Mariner, Montego and Mystique, in numerous inner, outer, rear and upper positions; treat those as representative examples rather than a complete vehicle list, because Ford reuses one clip across many bodies and model years and does not publish a single finite fitment chart for it. This clip snaps the liner, baffle or moulding into a body hole so it stays seated against wind and road forces; when one is broken, brittle or missing, the panel can flap, rattle, sag or detach, and a buyer reinstalling a fender liner or trim piece is often looking for exactly this clip. Because the suffix code denotes a specific size and material, confirm fit for your exact vehicle by VIN before ordering rather than relying on the sample applications above.

• Notes: Included with side shield. Included with rear molding.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov