Details

• Brand:

  

  

• SKU:

  W716350-S300

• Positions: Right, Left
• Other Names:

  Rocker Molding Clip, Rocker Molding Nut, Pin Special

• Description:

  This is a genuine Ford rocker panel molding clip, a special push-in pin built on the HM2 base, supplied in black and primed finishes, that secures rocker panel moldings to the body. Ford dealer catalogs list it under several names including Rocker Panel Molding Clip, Rocker Molding Retainer, and Special Pin, all referring to the same fastener, and it is supplied with the rocker molding in some applications. It snaps into a body panel hole and engages the back of the molding so the trim sits flush and stays tight against the body without lifting, fluttering, or rattling at speed. You will find it used across a range of Ford applications including Bronco Sport, Fusion, MKZ, Police Responder Hybrid, and SSV Plug-In Hybrid, with applications spanning a broad range of model years. These are representative examples rather than a complete list, since Ford shares this hardware across many positions. A broken or missing clip lets the rocker molding loosen, pull away from the body, vibrate, or fall off, and because each molding uses several clips a single failure can leave a section flapping. Ford supplies these as standard service hardware because they are commonly damaged during trim removal, so they are typically replaced whenever a molding is taken off. Confirm the correct clip for your specific vehicle and finish against your VIN before ordering, since coverage varies by application.

• Notes: Included with rocker molding.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov