Details

• Brand:

  

  

• SKU:

  388930-S

• Positions: Rear Upper, Front Upper Upper
• Other Names:

  Upper Retainer Clip, Bumper Cover Retainer, Pin

• Description:

  This is the genuine Ford bumper cover clip and trim panel retainer, a nylon fastener sized for a 1/4 inch hole with about a 1 inch head and a 9/32 inch stem, used across a very broad range of vehicles including Crown Victoria, Five Hundred, Grand Marquis, F-150, Expedition, Explorer and Mustang among many others. The clip secures a bumper cover, trim panel, molding or similar piece to the body, holding it tight against the surface so it stays aligned and rattle-free. The wide head spreads holding force and gives a finished look, while the stem locks into the mounting hole. These clips are routinely needed when the originals break during panel removal, become brittle with age, or are lost, leaving a cover or trim piece loose, sagging or rattling. Fitting fresh clips restores a secure, properly aligned panel. For a clean repair, confirm the hole size matches the clip, line up the panel before seating the clips, and press each clip fully home until it locks; replace any clip that is cracked rather than reusing it. Renewing all the clips for a panel at once gives the most even, secure fit. Because clip dimensions vary by location, confirm the application and hole size before ordering. Genuine Ford construction ensures the clip matches the original head, stem and locking design for a tight, finished fit.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov