Details

• Brand:

  

  

• SKU:

  W716076-S300

• Positions: Left, Right, Front
• Other Names:

  Valance Panel Retainer, Pin Retaining

• Description:

  This is a genuine Ford wheel flare pin, a push-in retainer that Ford dealer catalogs list under several names including Wheel Flare Pin, Valance Panel Retainer, Retaining Pin, Wheel Arch Molding Clip, and Valance Panel Clip, all referring to the same fastener. This part supersedes the earlier number W712771-S300. It snaps into a body panel or bracket hole and engages the back of a wheel flare, valance panel, or molding so the trim sits flush and stays secure without lifting, vibrating, or pulling away at speed. You will find it used across a range of Ford applications including Escape, Explorer, Police Interceptor Utility, and F-250 Super Duty, with applications spanning a broad range of model years. These examples are representative rather than a complete list, since Ford shares this hardware across many positions. A broken or missing wheel flare pin lets the flare, valance, or molding it secures loosen, sag, vibrate, or fall off, and because each component uses several pins a single failure can leave a section flapping or a flare hanging loose. Ford supplies these as standard service hardware because they are commonly damaged during trim and flare removal, so they are typically replaced whenever the related panel is taken off. Confirm the correct pin for your specific vehicle and position against your VIN before ordering, since coverage varies by application.

• Replaces:

  w712771s300

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov