Details

• Brand:

  

  

• SKU:

  W715783-S439

• Positions: Left Front, Left Rear, Right Front, Right Rear, Front, Front Rear
• Other Names:

  Retainer Retainer Nut, Headliner Nut, Front Console Nut, Retainer Nut, Retainer Plate Retainer Nut, Sun-Visor Nut, Pull Handle Nut, Rear Retainer Nut, Headliner Retainer Nut, Nut Adjusting Screw

• Description:

  This is a genuine Ford grip handle retainer nut, a small M4.2 nut built on the HN1 base that secures interior grip handles, sun visors, and headliner and header trim to the body. Ford dealer catalogs list it under several names including Grip Handle Retainer Nut, Adjusting Screw Nut, Sun Visor Nut, and Headliner and Header Trim Nut, all referring to the same fastener. It threads onto a stud or screw and clamps the handle, visor, or trim component tight so it stays seated and does not loosen, droop, or rattle. You will find this nut used across a wide range of Ford and Lincoln applications including Escape, Fusion, Mustang, Edge, MKC, MKX, and Nautilus, often supplied with the headliner and header trim, with applications spanning a broad range of model years. These are representative examples rather than a complete list, since Ford shares this hardware across many platforms. A loose or missing retainer nut lets the grip handle, sun visor, or trim piece it secures move, sag, sit proud, or rattle, which can leave a handle floppy or a visor that will not hold position. Ford supplies these as standard service hardware because they are commonly dropped or lost during headliner and trim work, so they are typically replaced whenever the related trim is removed. Confirm the correct nut for your specific vehicle and position against your VIN before ordering, since coverage varies by application.

• Notes: Included with Headliner. Included with header trim.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov