Details

• Brand:

  

  

• SKU:

  377977-S

• Positions: Left Rear
• Other Names:

  Insert Panel Plug, Vent Plug, Cowl Top Panel Plug, Cowl Cover Cap, Plug Blanking

• Description:

  This is the genuine Ford blanking cover plug in the 3/4 inch size from the HP10 base hardware family, used across a broad range of Ford, Lincoln and Mercury vehicles to close an unused hole in a cowl, body panel, floor or housing. The plug seals the opening against water, dust, fumes and noise while providing a clean, finished look, and it is the kind of small but important part that keeps the cabin dry and quiet. These plugs are commonly needed when an original has fallen out, dried up and cracked, or been removed during repair, leaving a hole that can let in moisture and road contaminants and create wind or road noise. Fitting the correct plug restores a sealed, finished panel. For a clean installation, confirm the hole diameter matches the plug, clean the area so the plug seats fully, and press it in until it is properly seated and retained; a plug that is too small or not fully seated will leak or work loose. Because hole sizes vary throughout the body, confirm the opening size and the application before ordering. Genuine Ford construction ensures the plug matches the original diameter, sealing lip and material so it stays put and keeps the opening weathertight.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov