Details

• Brand:

  

  

• SKU:

  DU-90

• Positions: Left Outer, Right, Left Upper, Right Outer, Right Upper
• Other Names:

  Motorcraft™ Camshaft Sensor, Motorcraft™ Camshaft Position Sensor, Sensor Assembly

• Description:

  This genuine Motorcraft camshaft position sensor, Ford service number AT4Z-6B288-A and cataloged as an Engine Camshaft Position Sensor, monitors the rotational position of the camshaft and reports it to the powertrain control module so the engine can correctly sequence fuel injection, coordinate spark timing, and command variable camshaft timing. It is a Hall-effect style sensor that reads a target on the cam and produces a digital signal used for synchronization with the crankshaft position sensor. This is a broad, cross-platform service part used across many 2007 through 2019 Ford car, truck, and utility applications spanning multiple engine families, which is why it is listed as a multi-vehicle component rather than for a single model. A failing camshaft position sensor commonly sets diagnostic trouble codes such as P0340, P0341, P0344, or P0345, and produces symptoms including a hard start or extended crank, a no-start condition, stalling, rough idle, hesitation, misfire, and a flashing check engine light. Buyers searching for this sensor are typically diagnosing an intermittent no-start or a cam or crank correlation code. Installation is straightforward: disconnect the electrical connector, remove the hold-down fastener, replace the sensor with a fresh O-ring seated in clean oil, and clear codes so the module can relearn. As a genuine Motorcraft sensor it delivers the correct signal characteristics and connector fitment that generic substitutes often fail to match.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov