Details

• Brand:

  

  

• SKU:

  DU-97

• Other Names:

  Motorcraft™ Engine Camshaft Position Sensor, Motorcraft™ Camshaft Sensor, Sensor Camshaft Position

• Description:

  This is a genuine Motorcraft engine camshaft position sensor that monitors the rotational position and speed of the camshaft and reports that signal to the powertrain control module. The module uses the input to sequence fuel injection and coil-on-plug ignition timing, so an accurate reading is essential for the engine to start and run correctly. It fits a wide range of Ford applications, including 2013-2019 Escape and 2013-2020 Fusion along with related compact-platform vehicles using the 1.5L, 2.0L and 2.5L engine families, which is why it is offered as a broad multi-vehicle Motorcraft service part rather than a single-model item. Drivers who need this sensor are typically experiencing a check engine light with camshaft position codes such as P0340 or P0341, extended cranking or a no-start condition, a rough or surging idle, intermittent stalling, engine misfire, or reduced fuel economy. The sensor is a direct plug-in replacement with a single electrical connector and a hold-down bolt, and no dealer programming is required after installation. Inspect the O-ring and mounting bore for oil contamination during service and confirm the connector locks fully to prevent an intermittent signal.

WARNING: California Proposition 65

×

California Proposition 65

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov